Top.Mail.Ru

NArFU scientists have found a way to increase the efficiency of a biofuel boiler

Scientists from the Northern Arctic Federal University have patented a new design of a mine furnace for burning biofuel and peat. The development makes it possible to increase the efficiency of the boiler and reduce harmful emissions into the atmosphere, writes TASS.

According to experts, the innovations will have a tangible effect: the gross efficiency of the boiler will increase by at least 1.5% due to a reduction in heat losses; nitrogen oxide emissions will be reduced by 10–20%; carbon monoxide emissions will decrease by 15–30%.

Nowadays, mine furnaces are widely used for the utilization of small wood biofuels (sawdust, shavings, wood chips). Their feature is combustion chambers with a high neck, where wet fuel dries before entering the combustion zone. The process resembles the operation of an inclined conveyor: as the fuel dries and changes its structure, it moves itself along the grates into the combustion and afterburning zones.

Viktor Lyubov, a scientist at the Laboratory of Technologies for the Use of Alternative Energy Sources in the Arctic Zone of the Russian Federation, together with graduate student Ilya Tsypnyatov (Department of Heating Engineering and Thermal Power Engineering at VSHENiG) studied the operation of ten mine furnaces at enterprises in the Arkhangelsk region. During the study, they identified two key problems that reduce the effectiveness of the devices:

Accumulation of fuel particles in the lower part of the inclined grille. The seals interfered with the movement of the combustible mixture, disrupted the uniform distribution of air and led to incomplete combustion. Stagnation of coke provoked combustion in the loading funnel and fuel hose.

Heat losses in the fuel supply area due to “suction” of outside air.

To eliminate the shortcomings, scientists proposed the following solutions: modernized the design of the firebox to eliminate fuel accumulation and incomplete combustion; increased the tightness of the fuel input unit, which reduced heat losses and eliminated the risk of ignition in the lower part of the fuel hose and the neck of the combustion device.

The development can be used in the design of boiler houses operating on biofuel, as well as lump and briquetted peat with low ash content (up to 10% by dry weight).